20 Ton Heavy Duty Pneumatic Air Hydraulic Bottle Jack with Manual Hand Pump - Ideal for Auto Repair, Truck & Travel Trailer Lifting, Vehicle Maintenance & Emergency Roadside Assistance

I purchased this jack to specifically replace the 20 ton bottle jack on my Harbor Freight 20 Ton hydraulic press. In terms of the jack and the functionality, it works well. It is a bit taller than the original jack, so installing it with the springs on the press did take some doing. I removed one of the springs after loosening up the carriage bolts as much as possible, and then allowed the press carriage to drop on one side. From there, I removed the old jack and installed the new one, and then used a toe jack to raise the carriage back to level and then a bit more than level so that I could reinstall the spring I disconnected.I then replaced the OEM hose with a longer 6' Goodyear hose, connected it to a 2-way pneumatic pedal, and installed a 3' Goodyear hose with a quick connect. I also moved the origional air control valve from the old hose to the new one and installd a quick coupler on the pedal. I did this so that I could use the jack with the pedal or disconnect it from the pedal and use it like it was originally designed. It works perfectly in this configuration, since the origional control valve has a bail to hold the valve open which I use when connected to the pedal.The only dings I'd give the jack is the condition in which it arrived. The bail on the control valve had been ripped out during shipping, so I had to put that back together as best I could. Also the jack showed a lot of signs of paint chipping. Make no mistake, this is not a fancy jack. Additionally, the handle it comes with is of poor quality IMO. The handle that came with the press was far better. Anyhow, for my needs, it does what I wanted. For that, I'm giving it 5 stars. If I was just using it as it came as a normal jack, i'd probably rate it 3.5-4 stars, since I'd have to use that less than ideal jack handle.